followup

Author: thinkyhead

Marlin/src/gcode/calibrate/G28.cpp

@@ -381,20 +381,20 @@ void GcodeSuite::G28() {
                    needX = _UNSAFE(X), needY = _UNSAFE(Y), needZ = false, // UNUSED
                    needI = _UNSAFE(I), needJ = _UNSAFE(J), needK = _UNSAFE(K),
                    needU = _UNSAFE(U), needV = _UNSAFE(V), needW = _UNSAFE(W)
-                 ),
+                 )
                  NUM_AXIS_LIST_(              // Home each axis if needed or flagged
                    homeX = needX || parser.seen_test('X'),
                    homeY = needY || parser.seen_test('Y'),
                    homeZZ = homeZ,
                    homeI = needI || parser.seen_test(AXIS4_NAME), homeJ = needJ || parser.seen_test(AXIS5_NAME),
                    homeK = needK || parser.seen_test(AXIS6_NAME), homeU = needU || parser.seen_test(AXIS7_NAME),
                    homeV = needV || parser.seen_test(AXIS8_NAME), homeW = needW || parser.seen_test(AXIS9_NAME)
-                 ),
+                 )
                  home_all = NUM_AXIS_GANG_(   // Home-all if all or none are flagged
                       homeX == homeX, && homeY == homeX, && homeZ == homeX,
                    && homeI == homeX, && homeJ == homeX, && homeK == homeX,
                    && homeU == homeX, && homeV == homeX, && homeW == homeX
-                 ),
+                 )
                  NUM_AXIS_LIST(
                    doX = home_all || homeX, doY = home_all || homeY, doZ = home_all || homeZ,
                    doI = home_all || homeI, doJ = home_all || homeJ, doK = home_all || homeK,

Marlin/src/gcode/config/M217.cpp

@@ -206,7 +206,6 @@ void GcodeSuite::M217_report(const bool forReplay/*=true*/) {
         );
       }
       #endif
-    }
     #endif
 
     #if ENABLED(TOOLCHANGE_FS_PRIME_FIRST_USED)

buildroot/tests/mega2560

@@ -83,7 +83,7 @@ opt_set DEFAULT_AXIS_STEPS_PER_UNIT '{ 4000 }' \
         HOMING_BUMP_MM '{}' HOMING_BUMP_DIVISOR '{}' HOMING_FEEDRATE_MM_M '{}'
 opt_enable REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER
 opt_disable X_DRIVER_TYPE Y_DRIVER_TYPE Z_DRIVER_TYPE
-exec_test $1 $2 "X Axis Only | DOGM MarlinUI" "$3"
+exec_test $1 $2 "E Axis Only | DOGM MarlinUI" "$3"
 
 #
 # Mixing Extruder with 5 steppers, Greek