Skip to content

[BUG] Z PRobe Wizard travels at 0 possibly dragging on plate #25491

@neclimdul

Description

@neclimdul

Did you test the latest bugfix-2.1.x code?

Yes, and the problem still exists.

Bug Description

The wizard moves to the center of the build plate directly after homing. Unless your build plate is perfectly flat or dips toward the middle this will drag your nozzle over the surface.

I'm using both a probe and a homing switch to avoid driving my nozzle into the bed in the rare cases where the probe doesn't deploy and my suspicion is its limited to this case because the home with a probe would have the offset of the probe. If that's the case, it might just be nice to allow some sort of travel height offset in the configuration.

Bug Timeline

No response

Expected behavior

Nozzle doesn't drag on build plate during probe wizard.

Actual behavior

Dragging over the buildpate

Steps to Reproduce

  1. Start wizard
  2. Observe dragging

Version of Marlin Firmware

2.1.x@2b86daa30bb4705f8369ca27dd5fe723c90ef634

Printer model

Ender 5 Pro

Electronics

BTT SKR Mini E3 and a BLTouch

Add-ons

No response

Bed Leveling

No Bed Leveling

Your Slicer

None

Host Software

None

Don't forget to include

  • A ZIP file containing your Configuration.h and Configuration_adv.h.

Additional information & file uploads

galetea.tar.gz

Metadata

Metadata

Assignees

No one assigned

    Labels

    No labels
    No labels

    Type

    No type

    Projects

    No projects

    Milestone

    No milestone

    Relationships

    None yet

    Development

    No branches or pull requests

    Issue actions