I could not disarm arduplane on parrot disco after installation arduplane from your manual.

[hsy77101]

Thank you for your valuable data.
I tried to do after reading your manual.
But it didn't work properly.

Parrot Disco FW (installed through the Parrot Freeflight app) = v 1.7.1

The following is my procedure.

1. Turn on disco, and then connected pc wifi to wifi of parrot disco.

2. I copied your ardupilot files (WCS_ParrotDisco_Conversion-master\Autopilot files\Latest Arduplane FW)
   to "/internal_000" of parrot disco chuck using Filezilla.

3. Power off parrot disco and then Power on parrot disco.

4. Using Qgroundcontrol v3.5.6 , I connected parrot disco.

5. I upload \WCS_ParrotDisco_Conversion-master\Autopilot files\Latest ParameterFinal_FW3.9.8_210206.params
   to parrot disco by tool of Qgroundcontrol v3.5.6.

6. I could see fail message of writing parameter on Qgroundcontrol.

7. But I could not see all of parameter after copying ardupilot file to parro disco chuck.

8. And I could not disarm parrot disco. and I could not find parameter on qgroundcontrol v3.5.6.

9. Power off , Power on and Clicking power button on Disco Three time

10. I could not also disarm parrot disco. and I could not find parameter on qgroundcontrol.

How can I solve it?